MICROSTRUCTUR AND MICROHARDNESS OF LASER CLADDING Ni BASED ON COLD ROLLED STEEL

Authors

  • Maryam A Ali Bash Department of Production Engineering and Metallurgy University of Technology, Baghdad, Iraq
  • Ali M Mustfa Department of Production Engineering and Metallurgy University of Technology, Baghdad, Iraq
  • Ali M Resan Department of Production Engineering and Metallurgy University of Technology, Baghdad, Iraq
  • Firas F Sayyid Department of Production Engineering and Metallurgy University of Technology, Baghdad, Iraq
  • Adnan I Mohammed Department of Production Engineering and Metallurgy University of Technology, Baghdad, Iraq

DOI:

https://doi.org/10.32852/iqjfmme.Vol18.Iss2.85

Keywords:

Cold rolled steel, High power laser, Functionally graded material, Recrystallization, Grain growth, Recovery

Abstract

A study is reported of the laser cladding of a nominal composition of Ni 5 wt% Al on cold
rolled low carbon steel (0.16 wt% C), using a high power continuous CO2 laser. The severe
rolled microstructure of steel was changed considerably at the heat affected zones under all
specific energies. The cladded coatings showed the presence of ? solid solution and ?
(NiAlFe) phases. Sound metallurgical bonding with absence of porosity and cracks was
observed between the substrate and the clad coat at specific energy higher than 80 J/mm2.
The ferrite and pearlite microstructure of the substrate was changed to martensite at the region
adjacent to the clad interface. It followed by large grains of austenite/ferrite and pearlite
(grain growth zone), fine grains of austenite/ferrite and pearlite (recrystallization zone) and
very small zone of relatively small change of cold structure (recovery zone). The last zone
was confirmed by micro hardness as a recovery zone.
This investigation confirms clearly the possibility of formation different structures of grain
growth, recrystallization and recovery at the laser heat affected cold rolled low carbon steel.
The observed results suggest the developing of a new technique to obtain tentative
functionally graded material.

Downloads

Published

2018-08-04

How to Cite

Ali Bash, M. A., Mustfa, A. M., Resan, A. M., Sayyid, F. F., & Mohammed, A. I. (2018). MICROSTRUCTUR AND MICROHARDNESS OF LASER CLADDING Ni BASED ON COLD ROLLED STEEL. THE IRAQI JOURNAL FOR MECHANICAL AND MATERIALS ENGINEERING, 18(2), 201–213. https://doi.org/10.32852/iqjfmme.Vol18.Iss2.85